Rule ID
SV-224252r1141588_rule
Version
V7R2
CCIs
BMC MAINVIEW can run with sensitive system privileges, and potentially can circumvent system controls. Failure to properly control access to product resources could result in the compromise of the operating system environment, and compromise the confidentiality of customer data. Many utilities assign resource controls that can be granted to systems programmers only in greater than read authority. Resources are also granted to certain nonsystems personnel with read only authority.
Refer to the following report produced by the ACF2 Data Collection and dataset and Resource Data Collection: - SENSITVE.RPT(ZMVZ0020). - ACF2CMDS.RPT(RESOURCE) - Alternate report. Automated Analysis Refer to the following report produced by the dataset and Resource Data Collection: - PDI(ZMVZ0020). Verify that the accesses to resources and/or generic equivalent are properly restricted according to the requirements specified in BMC MAINVIEW Resources table in the z/OS STIG Addendum. If the following guidance is true, this is not a finding. The ACF2 resources are defined with a default access of PREVENT. The ACF2 resource access authorizations restrict access to the appropriate personnel.
The ISSO will work with the systems programmer to verify that the following are properly specified in the Access Control Program (ACP). (Note: The resource type, resources, and/or resource prefixes identified below are examples of a possible installation. The actual resource type, resources, and/or prefixes are determined when the product is installed on a system through the product's installation guide and can be site specific.) Use BMC MAINVIEW Resources table in the z/OS STIG Addendum. This table lists the resources, access requirements, and logging requirement for BMC MAINVIEW. Ensure the guidelines for the resource type, resources, and/or generic equivalent specified in the z/OS STIG Addendum are followed. The ACF2 resources as designated in the above table are defined with a default access of PREVENT. The ACF2 resource access authorizations restrict access to the appropriate personnel as designated in the above table. The following commands are provided as a sample for implementing resource controls: $KEY(BBM) TYPE(BMV) ssid.CN UID(autoaudt) ALLOW ssid.CN UID(dasdaudt) ALLOW ssid.CN UID(mqsaaudt) ALLOW ssid.CN UID(Mainview STCs) ALLOW ssid.CN UID(mvzread) ALLOW ssid.CN UID(mvzupdt) ALLOW ssid.CN UID(pcspaudt) ALLOW ssid.CN UID(syspaudt) ALLOW - UID(*) PREVENT