V-221039

Discussion

An RD provides uniqueness to the customer address spaces within the MPLS L3VPN infrastructure. The concept of the VPN-IPv4 and VPN-IPv6 address families consists of the RD prepended before the IP address. Hence, if the same IP prefix is used in several different L3VPNs, it is possible for BGP to carry several completely different routes for that prefix, one for each VPN. Since VPN-IPv4 addresses and IPv4 addresses are different address families, BGP never treats them as comparable addresses. The purpose of the RD is to create distinct routes for common IPv4 address prefixes. On any given PE switch, a single RD can define a VRF in which the entire address space may be used independently, regardless of the makeup of other VPN address spaces. Hence, it is imperative that a unique RD is assigned to each L3VPN and that the proper RD is configured for each VRF.

Check Content

Review the design plan for MPLS/L3VPN to determine what RD has been assigned for each VRF. Review the switch configuration and verify that the correct RD is configured for each VRF. In the example below, route distinguisher 13:13 has been configured for customer 1.

ip vrf CUST1
 rd 13:13

Note: This requirement is only applicable for MPLS L3VPN implementations.

If the wrong RD has been configured for any VRF, this is a finding.