← Back to VMware vSphere 8.0 vCenter Security Technical Implementation Guide

V-258937

CAT II (Medium)

The vCenter Server must set the distributed port group Promiscuous Mode policy to "Reject".

Rule ID

SV-258937r961863_rule

STIG

VMware vSphere 8.0 vCenter Security Technical Implementation Guide

Version

V2R3

CCIs

CCI-000366

Discussion

When promiscuous mode is enabled for a virtual switch, all virtual machines connected to the port group have the potential of reading all packets across that network, meaning only the virtual machines connected to that port group. Promiscuous mode is disabled by default on the ESXi Server, and this is the recommended setting.

Check Content

If distributed switches are not used, this is not applicable.

From the vSphere Client, go to "Networking".

Select a distributed switch >> Select a port group >> Configure >> Settings >> Policies.

Verify "Promiscuous Mode" is set to "Reject".

or

From a PowerCLI command prompt while connected to the vCenter server, run the following commands:

Get-VDSwitch | Get-VDSecurityPolicy
Get-VDPortgroup | ?{$_.IsUplink -eq $false} | Get-VDSecurityPolicy

If the "Promiscuous Mode" policy is set to accept, this is a finding.

Fix Text

From the vSphere Client, go to "Networking".

Select a distributed switch >> Select a port group >> Configure >> Settings >> Policies.

Click "Edit".

Click the "Security" tab.

Set "Promiscuous Mode" to "Reject".

Click "OK".
 
or

From a PowerCLI command prompt while connected to the vCenter server, run the following commands:

Get-VDSwitch | Get-VDSecurityPolicy | Set-VDSecurityPolicy -AllowPromiscuous $false
Get-VDPortgroup | ?{$_.IsUplink -eq $false} | Get-VDSecurityPolicy | Set-VDSecurityPolicy -AllowPromiscuous $false